Kia Rio: SRS Control Module (SRSCM) Installation
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Install the SRSCM with the SRSCM mounting nuts (A).
|
| 4. |
Connect the SRSCM harness connector.
|
| 5. |
Install the rear heating joint duct and floor console. (Refer
to the Body group - "Console")
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the SRSCM, confirm proper system operation:
|
SRS Control Module (SRSCM) Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
See also:
Front Stabilizer Link Inpesction
Check the front stabilizer link ball joint for damage.
-
Torn boot
-
Opened boot
-
Displaced ring
...
Child restraint system
Children riding in the car should sit in the rear seat and must always be properly
restrained to minimize the risk of injury in an accident, sudden stop or sudden
maneuver. According to accident s ...
Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of the F ...
Copyright © www.kirmanual.com 2014-2024