|
1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Remove the front wheel guard.
(Refer to the Body group - "Exterior")
|
3. |
Left side - Remove the air duct assembly.
Right side - Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
|
4. |
Remove the front impact sensor (B) mounting bolt.
|
5. |
Disconnect the front impact sensor connector (A).
|
6. |
Remove the front impact sensor.
|
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Service Standard
Item
Specification
Ignition Timing (°)
BTDC 3 ± 10
Idle Speed (rpm)
A/C OFF
Neutral, N, P-range
630 ± 100
D-range
...
Dynamic Damper Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...