|
1. |
Install the new front impact sensor.
|
2. |
Tighten the front impact sensor mounting nut.
|
3. |
Connect the front impact sensor connector.
|
4. |
Left side - Install the air duct assembly.
Right side - Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
|
5. |
Install the front wheel guard.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the Front Impact Sensor, confirm proper system
operation:
|
Checking Cables And Wires
1.
Check the terminal for tightness.
2.
Check terminals and wires for corrosion from battery electrolyte,
etc.
3.
...
Oil Pump Unit (OPU) Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the crash pad lower panel. (Refer to “Crash pad” in BD
group.)
...
Specification
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35 ...