Pressure Side Impact Sensor |
|
1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Remove the front door trim.
(Refer to the Body group - "Front door")
|
3. |
Disconnect the pressure side impact sensor connector (A) and remove
the pressure side impact sensor mounting screws (B).
|
1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
3. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
4. |
Disconnect the side impact sensor connector (A).
|
5. |
Loosen the side impact sensor mounting bolt and remove the side
impact sensor (B).
|
Specification
Smart Key Unit
Items
Specification
Rated voltage
DC 12V
Operating voltage
DC 9 ~ 16V
Operating temperature
-30°C ~ 75°C (- ...
Compressor Installation
1.
Make sure of the length of compressor mounting bolts, and then
tighten it with the specified tightening order.
Tightening torque :
...
Inspection
[Rotor]
1.
Check that there is continuity between the slip rings (C).
2.
Check that there is no continuity between the slip ...