Be sure to install the harness wires so they will not pinch or
interfere with other parts.
|
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfere with other parts.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Oil Pan: Installation
1.
Install the oil pan.
(1)
Using a razor blade and gasket scraper, remove all the
old packing material from the gasket surfaces.
...
Windshield Wiper-Washer Switch Removal
Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - &qu ...
Description
Fuel Pressure Regulator Valve is installed on the high pressure fuel pump
and controls fuel flow flowing into the injectors in accordance with the ECM
signal calculated based on various engin ...