Kia Rio Manuals

Kia Rio: Curtain Airbag (CAB) Module Installation - Airbag Module - Restraint - Kia Rio UB 2012-2024 Service ManualKia Rio: Curtain Airbag (CAB) Module Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

     
•
Never twist the airbag module during installation. If the airbag module is twisted, it may not operate as designed.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to the Body group- "Interior")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Curtain Airbag (CAB) Module Removal
1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the roof trim. (Ref ...

Airbag Disposal
Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airbags or side airbag ...

See also:

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replacin ...

Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : Replace I : I ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Categories


Copyright © www.kirmanual.com 2014-2024