Kia Rio: Anchor Pretensioner (APT) Installation
| 1. |
Remove ignition key from the vehicle.
|
| 2. |
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
|
| 3. |
Install the anchor pretensioner with a bolt.
|
| 4. |
Connect the anchor pretensioner connector.
|
| 5. |
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
|
| 6. |
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
|
| 7. |
Insert the seat belt to the anchor pretensioner (A).
|
| 8. |
Reconnect the battery negative cable.
|
| 9. |
After installing the anchor pretensioner, confirm proper system
operation:
|
Anchor Pretensioner (APT) Removal
1.
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
2.
Remove the seat belt after pushin ...
Brake System
...
See also:
TPMS Sensor Removal
Handle the sensor with care.
1.
Remove the tire. (Refer to "Tire Removal")
...
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated by the engine ...
Front Stabilizer Link Inpesction
Check the front stabilizer link ball joint for damage.
-
Torn boot
-
Opened boot
-
Displaced ring
...
Copyright © www.kirmanual.com 2014-2024