1. |
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
|
2. |
Remove the battery and ECM.
(Refer to Engine Electrical group - "Battery")
|
3. |
Remove the master cylinder.
(Refer to Master cylinder.)
|
4. |
Disconnect the vacuum hose (A) from the brake booster.
|
5. |
Remove the snap pin (A) and clevis pin (B).
|
6. |
Remove the brake booster mounting nuts (A).
|
7. |
Disconnect the brake tubes (A) from the HECU by unlocking the
nuts counterclockwise with a spanner.
|
8. |
Loosen the brake tube bracket mounting nuts (B).
|
9. |
Pivot the brake tubes (A) down out of the way.
|
10. |
Remove the brake booster (B).
|
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...
Tire pressure monitoring system
(1) Low tire pressure telltale / TPMS malfunction indicator
Each tire, including the spare (if provided), should be checked monthly when
cold and inflated to the inflation pressure recommended by ...
Back-up Lamp Switch Replacement
1.
Disconnect the back up lamp switch connector (A).
2.
Remove the back up lamp switch (A).
3.
...