Rear Brake Disc Thickness Check |
1. |
Check the brake pads for wear and fade.
|
2. |
Check the brake disc for damage and cracks.
|
3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 12 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
Rear Brake Pad Check |
1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
2. |
Check that grease is applied, to sliding contact points. Check
for metal damage to the pad and backing.
|
Yaw-rate and G Sensor Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the front seat (LH) assembly.
(Refer to the Bo ...
Lubricants
Engine
Lubricants
Quantity
Gasoline 1.6(MT)
BJ
GRB006
80g
TJ
SH06 - VX21
LH:130g, RH:115g
...
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...