Kia Rio: Parking Brake Adjustment
|
| 1. |
Remove the floor console to reach the adjusting nut.
|
| 2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
| 3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
| 4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) between operating lever (B) and stopper (C).
|
| 5. |
Parking brake lever in the car must be in fully loosened position.
|
| 6. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
| 7. |
Check the wheels of their free operation.
|
| 8. |
Install the floor console.
|
| 9. |
Test drive.
|
Installation
1.
Installation is the reverse of removal.
2.
Use a SST (09580-0U000) when installing the brake caliper assembly.
...
Rear Drum Brake
...
See also:
Operation
Passive Functions
The system allows the user to access the vehicle without having to perform
any actions (e.g. RKE button pressing) with the SMART KEY fob. It is sufficient
that a valid S ...
Front Wiper Motor Component Location
1. Cap
2. Nut
3. Wiper arm & blade
4. Rivet
5. Cowl top cover
6. Bolt
7. Wiper motor & linkage assembly
...
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
Copyright © www.kirmanual.com 2014-2024