Parking Brake Lever Stroke Adjustment |
1. |
Remove the floor console.
(Refer to Body group - "Floor console")
|
2. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
3. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
4. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
5. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
6. |
Install thd floor console.
(Refer to the Body group - "Floor console")
|
Parking Brake Shoe Clearance Adjustment |
1. |
Depress the brake pedal several times to set the self-adjusting
brake.
|
Re-setting of the parking brake is necessary after overhauling
the caliper body, or if the brake calipers, housing, parking brake cable
or brake discs have been changed.
|
1. |
Remove the floor console to reach the adjusting nut.
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) between operating lever (B) and stopper (C).
|
5. |
Parking brake lever in the car must be in fully loosened position.
|
6. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
7. |
Check the wheels of their free operation.
|
8. |
Install the floor console.
|
9. |
Test drive.
|
Auto Defogging Sensor (FATC only) Replacement
1.
Remove the auto defogging sensor cover (A).
2.
Disconnect the connector (B) and then remove the auto defogging
sensor (C).
...
Passenger Airbag (PAB) ModuleInstallation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least thirty seconds bef ...
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...