ESC Hydraulic System Diagram |
1. |
ESC Non-operation : Normal braking.
|
2. |
ESC operation
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
In the event of inhibition of ABS functions by failure.
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is separated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the Parking Brake Switch is ON or brake fluid level is low.
|
- |
When the EBD function is out of order .
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is separated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the ESC function is inhibited by system failure.
|
- |
When the ESC control is operating. (Blinking - 2Hz)
|
- |
During diagnostic mode.(Except standard mode)
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization mode after IGN ON. (continuously 3 seconds).
|
- |
ESC Off lamp is On when driver input the ESC Off switch.
|
BCM Overview
The Body Control Module (A) supplies vehicle occupants with visual and
audible information and controls various vehicle functions.
To provide and receive information, the module is interface ...
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector in driver
side crash pad lower panel, turn the power on GDS.
2.
...
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2]
A/F Ratio (λ)
...