Kia Rio Manuals

Kia Rio: ESC Control Module Removal - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2024 Service ManualKia Rio: ESC Control Module Removal

1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the connector.
3.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:
A : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
B : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)


4.
Loosen the HECU bracket nuts (A), then remove HECU and bracket.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)



     
•
Never attempt to disassemble the HECU.
•
The HECU must be transported and stored in.
•
Never shock to the HECU.
5.
Remove the 3 bolts, and then remove the bracket from HECU.
Tightening torque:
11 ~ 14 N.m (1.1 ~ 1.4 kgf.m, 8.1 ~ 10.3 lb-ft)
ESC Control Module Components
1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module (HECU) 8. Damper 9. Bracket ...

ESC Control Module Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

See also:

Component Location
1. Head cap 2. Nut 3. Rear wiper arm & Blade 4. Packing (rubber) 5. Rear wiper motor assembly 6. Bolt ...

Input Speed Sensor Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

Components
1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & G sensor 5. Steering angle sensor 6. ABS Warning lamp 7. Parking brake/EBD warn ...

Categories


Copyright © www.kirmanual.com 2014-2024