1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the front seat (LH) assembly.
(Refer to the Body group - "Seat")
|
3. |
Disconnect the yaw rate & G sensor connector (A).
|
4. |
Remove the mounting nuts (B).
|
5. |
Installation is the reverse of removal.
|
■ longitudinal G sensor Calibration |
1. |
IG ON, ENG OFF
|
2. |
Stand the vehicle on a flat ground without any inclination.
|
3. |
Set the steering wheel at the center position.
|
4. |
Keep the vehicle under normal tire pressure condition and normal
loading condition.
|
5. |
Connect GDS to Data Link Connector(DLC).
|
6. |
Perform Longitudinal G Sensor Calibration.(figure 1).
|
7. |
Confirm success or failure of calibration.
|
Instructions
When Handling Refrigerant
1.
R-134a liquid refrigerant is highly volatile. A drop on the skin
of your hand could result in localized frostbite. When handling the
r ...
Specification
Item
Bulb Watt (W)
Bulb Type
Front
Head lamp (High)
60/55
H1
Head lamp (Low)
60/55
H7
Position lmap
...
Circuit Diagram
(M/T)
(A/T)
...