Kia Rio: Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning direction and speed of the steering
wheel.
The HECU uses the signals from the SAS when performing ESP-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe relay, etc.)
of the EPS system are located inside the steering column & EPS unit assembly
and the steering column. EPS unit assembly must not be disassembled to be inspected.
They must be replaced. (Refer to “ST (Steering system) Gr.”)
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer to the Body ...
The steering angle speed sensor detects the angle of the steering wheel
in order to which direction a user chooses.The sensor is detached on the Mutil-Function
Switch (MPS) under the steering ...
See also:
Shift Lever Adjustment
1.
In neutral position, disjoin select cable (A) from shift lever
assembly pin (B).
2.
Disconnect select adjuster (A) to an arrow.
...
Engine compartment
1. Engine Coolant Reservoir
2. Engine Oil Filler Cap
3. Brake/Clutch Fluid Reservoir
4. Air Cleaner
5. Fuse Box
6. Negative Battery Terminal
7. Positive Battery Terminal
8. Radiator Cap
9. E ...
4Door Front Body B
Hood hinge mounting hole (Ø11)
Fender apron upper member tooling hole (Ø6.6)
Engine mounting hole (&O ...