|
1. |
Remove the following items :
|
2. |
Carefully move the glass (A) until the glass mounting bolts are
visible, then loosen them.
[5 Door]
[4 Door]
|
3. |
Check that the glass moves smoothly.
|
|
1. |
Check that the door and body edges are parallel.
[5 Door]
[4 Door]
|
2. |
Place the vehicle on a firm, level surface when adjusting the
doors.
|
3. |
Adjust at the hinges (A) :
[5 Door]
[4 Door]
|
4. |
Grease the pivot portions of the hinges indicated.
|
5. |
Check for water leaks.
|
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker.
The striker will not move much, but will give some adjustment.
|
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches properly,
tighten the screws and recheck.
|
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54)
Current value(mA ...
Removal
1.
Remove the trunk trim in the trunk after removing the screws and
clips.
(Refer to the BD group - "Tailgate")
2.
Remove ...
Refrigerant System Service Basics
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a (R-134a) from the air conditioning
system.
...