Kia Rio: Front Bumper Replacement
|
| 1. |
After loosening the mounting clips, then remove the radiator grille
upper cover (A).
|
| 2. |
Loosen the front bumper upper (A) mounting clips.
|
| 3. |
After loosening the front bumper side’s mounting screw, then disconnect
the side’s.
|
| 4. |
Remove the front bumper lower mounting clips.
|
| 5. |
Disconnect the fog lamp connector (A).
|
| 6. |
Remove the front bumper cover (A).
|
| 7. |
Installation is the reverse of removal.
|
Front Bumper Components
1 . Radiator grille upper cover
2 . Front bumper cover
3 . Front bumper side bracket [LH]
4 . Front bumper side bracket [RH]
...
Rear Bumper Components
[5 Door]
1. Rear bumper cover
2. Rear bumper side bracket [RH]
3. Rear bumper side bracket [LH]
4. Rear bumper side under cover
[4 Door]
...
See also:
Hazard warning flasher lighting
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...
Specification
Air Conditioner
Item
Specification
Compressor
Type
DVE12 (Externally Controlled Variable Swash Plate Type)
Oil type & Capacity
PAG ...
Washer fluid
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer sol ...
Copyright © www.kirmanual.com 2014-2024