[5 Door] |
|
1. |
After loosening the mounting screws, then remove the rear combination
lamp (A).
|
2. |
Disconnect the rear combination lamp connector (A).
|
3. |
After loosening the rear bumper side’s mounting screws, then disconnect
the side’s.
|
4. |
Remove the rear bumper after pull out the rear bumper.
|
5. |
Loosen the rear bumper lower mounting bolts.
|
6. |
Loosen the rear bumper lower mounting clips.
|
7. |
Loosen the rear bumper side mounting screw and clips.
|
8. |
Push the lock pin, disconnect the rear bumper main connector (A).
|
9. |
Remove the rear bumper cover (A).
|
10. |
Installation is the reverse of removal.
|
[4 Door] |
|
1. |
Remove the rear combination lamp service hole (A).
|
2. |
Disconnect the connector (A) and then loosening the rear combination
lamp mounting nuts.
|
3. |
Remove the rear combination lamp (A).
|
4. |
After loosening the mounting clip and screws, then remove the
rear mud guard (A).
|
5. |
After loosening the rear bumper side’s mounting screw, then disconnect
the side’s.
|
6. |
Loosen the rear bumper lower mounting clips.
|
7. |
Loosen the rear bumper lower mounting bolts.
|
8. |
Loosen the rear bumper side mounting screw and clips.
|
9. |
Push the lock pin, disconnect the rear bumper main connector (A).
|
10. |
Remove the rear bumper cover (A).
|
11. |
Installation is the reverse of removal.
|
Installation
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
Inspection
Sprockets, Hydraulic Tensioner, Chain
Guide, Tensioner Arm
1.
Check the CVVT sprocket, crankshaft sprocket teeth for abnormal
wear, cracks or damage. Repla ...
Display settings
Press the key
Select [Display] through
TUNE knob or
key
Select menu through
TUNE knob
Mode Pop up
[Mode Pop up] Changes
/
selection mode
During On state, press the or
key to d ...