1. |
Remove the antenna jack from the audio unit and antenna.
|
2. |
Check for continuity between the center poles of antenna cable.
|
3. |
Check for continuity between the outer poles of antenna cable.
There should be continuity.
|
4. |
If there is no continuity, replace the antenna cable.
|
5. |
Check for continuity between the center pole (A) and outer pole
(B) of antenna cable. There should be no continuity.
|
6. |
If there is continuity, replace the antenna cable.
|
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
Transaxle Control Module (TCM) Replacement
When replacing the TCM, the vehicle equipped with immobilizer
must be performed the procedure as below.
[In the ...