1. |
Install the smart key unit.
|
2. |
Install the smart key unit mounting nuts and connector.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the interior 1 antenna.
|
2. |
Install the heater & A/C controller.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the interior 2 antenna.
|
2. |
Install the console.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the trunk antenna.
|
2. |
Install the trunk transverse trim.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the exterior bumper antenna.
|
2. |
Install the rear bumper.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the buzzer.
|
2. |
Install the left side wheel guard.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the trunk lid open switch.
|
2. |
Install the trunk trim.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
1. |
Install the outside handle.
|
2. |
Install the door trim.
|
3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect igni ...
SS-B Solenoid Valve(ON/OFF) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
...