Kia Rio: Special Service Tools
| Tool (Number and Name) |
Illustration |
Use |
| 09200-3N000 Engine support fixture (Beam) |
|
Removal and installation of the transaxle. Use this adapter (SST No. : 09200-1P100, 4X000) with the supporter (SST No. : 09200-2S200). ※Permit operating with 09200-38001. |
| 09200-1P100 Engine support fixture (Adapter) |
|
Removal and installation of the transaxle. Use this beam (SST No. : 09200-38001/09200-3N000) with the supporter (SST No. : 09200-2S200) and adapter (SST No. : 09200-4X000) |
| 09200-4X000 Engine support fixture (Adapter) |
|
Removal and installation of the transaxle. Use this beam (SST No. : 09200-38001/3N000) with the supporter (SST No. : 09200-2S200) and adapter (SST No. : 09200-1P100) |
| 09200-2S200 Engine support fixture (Supporter) |
|
Removal and installation of the transaxle. Use this beam (SST No. : 09200-38001/09200-3N000) with the adapter (SST No. : 09200-1P100, 4X000) |
| 09452-26100 Oil seal installer |
|
Installation of transaxle case oil seal. [Using with handle (SST No.:09231-H1100)] |
| 09231-H1100 Bar |
|
Installation of transaxle case oil seal. [Using with oil seal installer (SST No.:09452-26100)] |
| 09480-A3800 Inhibitor switch guide pin |
|
※ Engine support fixture special tool assembly drawing
| 1. 09200-3N000(Main bar) 2. 09200-3N000(Sub bar) 3. 09200-3N000(Handle) 4. 09200-3N000(Stopper) 5. 09200-3N000(Bolt-1) 6. 09200-4X000 (Adapter) 7. 09200-1P100(Supporter) 8. 09200-2S200(Supporter) 9. 09200-3N000(Nut) |
10. 09200-3N000(Snap ring) 11. 09200-3N000(Sub fixture) 12. 09200-3N000(Stopper) 13. 09200-3N000(Nut) 14. 09200-2S100(Spacer) 15. 09200-1P100(Sub fixture) 16. 09200-1P100(Nut) 17. 09200-3N000(Pin) |
Lubricants
Item
Specified lubricant
Quantity
Transaxle fluid
ATF SP-Ⅳ or equivalent
7.3L (1.93 U.S gal., 7.71 U.S.qt., 6.42 Imp.q ...
See also:
Steering Column and Shaft Replacement
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fro ...
Oil Pressure Switch: Inspection
1.
Check the continuity between the terminal and the body with an
ohmmeter. If there is no continuity, replace the oil pressure switch.
2.
...
5Door Actual-Measurement Dimensions
Front side member tooling hole (Ø6.6)
Front side member tooling hole (Ø6.6)
Side cover mounting hol ...
Copyright © www.kirmanual.com 2014-2024