Kia Rio: Specification - Accelerator Position Sensor (APS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2024 Service ManualKia Rio: Specification

Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35

Circuit Diagram


Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Circuit Diagram
(M/T) (A/T) ...

See also:

Removal
1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove ...

Engine start/stop button
Illuminated Engine start/stop button Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the d ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from sunroof Dirt accumulated in drain tube Clear dirt inside of drain Clogged drai ...

Copyright © www.kirmanual.com 2014-2024