1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Remove the floor console.
(Refer to the Body group - "Console")
|
4. |
Remove the rear heating joint duct (A).
|
5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
6. |
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove
the SRSCM.
|
Shift Lever Adjustment
Adjusting the control cable
1.
Set room side AT lever(shift lever) and automatic transaxle side
manual control lever to "N" position.
...
Ignition Coil: Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...
Brake fluid
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the r ...