Kia Rio: Starter: Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switchassembly.
|
| 2. |
After loosening the 2 screws (A), detach the magnetswitch assembly
(B).
|
| 3. |
Loosen the brush holder mounting screw (A) and the trough bolts
(B).
|
| 4. |
Remove the rear bracket (A) and brush holderassembly (B).
|
| 5. |
Remove the yoke (A).
|
| 6. |
Remove the packing (A), lever plate (B), lever (C), armature (D).
|
| 7. |
Press the stopper (A) using a socket (B).
|
| 8. |
After removing the stop ring (A) using stopper pliers (B).
|
| 9. |
Remove the stop ring (B), stopper (A), overrunningclutch (C) and
armature (D).
|
Starter: Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Starter: Reassembly
1.
Reassemble in the reverse order of disassembly.
...
See also:
Specifications
Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
22.0 ~ 26.0 [20°C(68°F)]
Fuel Ta ...
Circuit Diagram
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line (Refer to the ...
Copyright © www.kirmanual.com 2014-2024