Kia Rio: Starter: Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the starter cable (B) from the B terminal on the solenoid
then disconnect the connector from the S terminal (A).
|
| 4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Starter: Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
See also:
Description
Due to the considerably more frequent occurrence of starting operations,
the electrical load that occurs often leads to voltage dips in the vehicle network.
In order to stabilize the power s ...
Audio Unit Components
Terminal specification(PA30A)
No
Terminal Description
Condition
Specified Condition
A1
Loudspeaker Rear Left+
Needed connection to the ca ...
Seats
...
Copyright © www.kirmanual.com 2014-2024