1. |
Disconnect the battery negative terminal.
|
2. |
Remove the air duct and air cleaner assembly. (Refer to EM group)
|
3. |
Disconnect the starter cable (B) from the B terminal on the solenoid
then disconnect the connector (A) from the S terminal.
|
4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
5. |
Installation is the reverse of removal.
|
Removal
Rear Disc Brake Type
The parking brake cables must not be bent or distorted. This will
lead to stiff operat ...
Sub Frame Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Road warning
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenev ...