|
1. |
Remove the glass (A) by lifting it up.
|
2. |
Installation is the reverse of removal.
|
|
1. |
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
|
2. |
After loosening the mounting screws, then remove the motor assembly
(A).
|
3. |
Installation is the reverse of removal.
|
1. |
Open the glass fully.
|
2. |
After loosening the mounting screws, then remove the deflector
(A).
|
3. |
Installation is the reverse of removal.
|
1. |
Remove the follows parts :
|
2. |
After loosening the mounting bolts, then remove the assist handle
bracket (A).
|
3. |
After loosening the mounting bolts, then remove the sunroof center
bracket (A).
|
4. |
Disconnect the drain tubes (B).
|
5. |
After loosening the mounding bolts and nuts, remove the sunroof
assembly (A).
|
6. |
Installation is the reverse of removal.
|
1. |
Remove the sunroof assembly.
|
2. |
Remove the sunshade stopper (B).
|
3. |
Remove the sunshade assembly (A).
|
4. |
Installation is the reverse of removal.
|
1. |
Remove the sunroof assembly.
|
2. |
Remove a drip link assembly (A) after lowering a guide thoroughly
by pushing a slide to rear.
|
3. |
Remove the guide (A) and drip link (B).
|
4. |
Remove the drip link stopper (B).
|
5. |
Remove the drip link assembly (A).
|
6. |
Installation is the reverse of removal.
|
Smart key unit Removal
Smart key unit
[USA]
1.
Disconnect the negative(-) battery terminal.
2.
Remove the smart key unit (A) after disconnecting the c ...
Installation
•
Install the component with the specified torques.
•
...
A/C Pressure Transducer Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
...