Kia Rio: Sunroof Switch Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or remover, remove the overhead console cover
(A).
|
| 3. |
After loosening the mounting screws, then remove the overhead
console assembly (A).
|
| 4. |
Check for continuity between the terminals. If the continuity
is not as specified, replace the sunroof switch.
|
Circuit Diagram
...
Sunroof Motor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim. (Refer to the BD group - " Roof trim")
...
See also:
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS termi ...
Owner maintenance
The following lists are vehicle checks and inspections that should be performed
by the owner or an authorized Kia dealer at the frequencies indicated to help ensure
safe, dependable operation of y ...
Copyright © www.kirmanual.com 2014-2024