1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the temperature control actuator connector.
|
3. |
Verify that the temperature control actuator operates to the warm
position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool
position when connecting in the reverse.
|
4. |
Connect the temperature control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 5.
Specification
It will feedback current position of actuator to controls.
|
7. |
If the measured voltage is not within specification, substitute
with a known-good temperature control actuator and check for proper
operation.
|
8. |
Replace the temperature control actuator if it is proved that
there is a problem with it.
|
Tail Gate Adjustment
1.
After loosening the tail gate hinge (A) mounting bolt, adjust
the tail gate by moving it up or down, or right or left.
2.
Adjust the tai ...
Back-up Lamp Switch Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. W ...
Relay Box (Passenger Compartment) Removal
Passenger Compartment Junction Box
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to th ...