Kia Rio: TJ Joint Installation
| 1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
|
| 2. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and snap ring (B) on the driveshaft
splines (C).
|
| 3. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
| 4. |
Install the both boot band.
|
| 5. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
|||||||||||
| 6. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
| 7. |
Install the Front Driveshaft. (Refer to DS group - “Front Driveshaft”)
|
TJ Joint Inspection
1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
...
Dynamic Damper Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
See also:
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Installation
•
Install the component with the specified torques.
•
...
Spark Plug: Description
A spark plug is a device for delivering electric current from an ignition
system to the combustion chamber of a spark-ignition engine to ignite the compressed
fuel/air mixture therein by mean ...
Copyright © www.kirmanual.com 2014-2024