Kia Rio: Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
See also:
Signal Waveform
...
Installation
1.
Install the intake CVVT (A) and exhaust CVVT (B).
Tightening torque :
63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft)
...
Wiper blades
Blade inspection
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with f ...
Copyright © www.kirmanual.com 2014-2024