Kia Rio: TPMS Receiver Description
1. |
Mode
(1) |
Virgin State
A. |
The receiver as a sole part is shipped in this
state. Replacement parts should therefore arrive in
this state.
|
B. |
In this state, there is no sensor monitoring and
no DTC monitoring.
|
C. |
The state indicates that platform specific parameters
must be written to the receiver and that sensors are
un-learned.
|
|
(2) |
Normal State
A. |
In order for tire inflation state and DTC monitoring
to occur, the receiver must be in this state.
|
B. |
In this state, automatic sensor learning is enabled.
|
|
(3) |
Test State
A. |
This state is only used in manufacturing plant
to check RF transmission between sensor and receiver.
|
|
|
2. |
Overview
A. |
Receives RF data from sensor.
|
B. |
Uses sensor data to decide whether to turn on TREAD Lamp.
|
C. |
Learn TPM sensor for under inflation monitoring automatically.
|
D. |
Uses sensor information, distance travelled, background
noise levels, Auto-learn status, short / open circuit output
status, vehicle battery level, internal receiver states to determine
if there is a system or a vehicle fault.
|
|
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
1.
General Function
A.
Auto-learn takes place only once per Ignition cycle.
B.
On successful compl ...
See also:
Delivery Pipe Installation
•
Do not use already used injector fixing clip again.
...
Cowl Top Cover Replacement
1.
Remove the wiper arm cover (B).
2.
After loosening the mounting nuts, then remove the wiper arm (A).
Tightening to ...
Brake Switch Removal
1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel. (Refer to the Body group-"crash
pad")
3.
...