Kia Rio: TPMS Receiver Replacement
When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is used
to replace the faulty part i.e. it must be Low Line and not High Line
in order to have the correct inflation warning thresholds set.
|
| 1. |
Disconnect vehicle battery.
|
| 2. |
Remove the glove box.
(Refer to BD group - "Crash Pad")
|
| 3. |
Remove the receiver (A) and fit bracket assembly to new part.
|
| 4. |
Secure new part to vehicle and fit connector.
|
| 5. |
Re-connect battery and turn Ignition on.
|
| 6. |
Check that TREAD Lamp flash rate matches Virgin State indication.
|
| 7. |
After replacing the receiver, learn by using self-diagnosis device(GDS).
|
[Wheel Sensor ID Writing (Wireless) initialization]
[Wheel Sensor ID Writing (Wireless) 1]
[Wheel Sensor ID Writing (Wireless) 2]
TPMS Receiver Operation
1.
General Function
A.
Auto-learn takes place only once per Ignition cycle.
B.
On successful compl ...
TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
See also:
Description
Keyless Entry System
The keyless entry system allows you to lock and unlock the vehicle with
the remote transmitter. When you push the LOCK button, all doors lock. When
you push the UNLOC ...
Hands free mic Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to the BD group - "Roof trim")
...
Components Location
1. Automatic transaxle
2. Valve body assembly
3. Oil pump assembly
...
Copyright © www.kirmanual.com 2014-2024