1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side check
point. If the problem is found, repair it.
|
2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it.
|
3. |
If problem is not found in Step 1 and 2, the TCM could be faulty.
If so, make sure there were no DTC's before swapping the TCM with a
new one, and then check the vehicle again. If DTC's were found, examine
this first before swapping TCM.
|
4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be broken)
into a known-good vehicle and check the vehicle. If the problem occurs
again, replace the original TCM with a new one. If problem does not
occur, this is intermittent problem (Refer to “Intermittent Problem
Inspection Procedure” in Basic Inspection Procedure).
|
Windshield Glass Components
1. Windshield glass
2. Windshield glass moulding
...
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Description
1.
The MF(Maintenance Free) battery is, as the name implies, totally
maintenance free and has no removable battery cell caps.
2.
The MF(Mai ...