1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
2. |
Select the vehicle model and then do "CODE SAVING"
|
3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the
screen will be shown as below.
|
4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1 to 4
and then code saving is completed.
|
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a LED lamp check.
T ...