1. |
Using a screwdriver or remover, remove the mirror (A) from th
mirror holder.
Becareful not to damage to the clip.
|
2. |
Remove the front cover (A), after loosening 3 screws.
|
3. |
Remove the rear cover (A).
|
4. |
Disconnect the mirror connector.Remove the door mirror turn signal
lamp (A) after loosening screw.
|
SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
▷ Control type : Normal low type
Control pressure kpa (kgf/cm², psi)
490.33(5.0, 71.12)
Internal resistance( ...
Console Replacement
Floor Console Replacement
[M/T]
•
A plastic trim tool is recommended, but if p ...
SS-A Solenoid Valve(ON/OFF) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...