1. |
Turn ignition switch OFF.
|
2. |
Disconnect the solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
|
Anchor Pretensioner (APT) Removal
1.
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
2.
Remove the seat belt after pushin ...
Front Fog Lamps Removal
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the fog lamp connector (A).
3.
Remove t ...
Filler-Neck Assembly Installation
1.
Installation is reverse of removal.
Filler-neck assembly bracket
installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...