Kia Rio: Valve Body Installation
1. |
Installation is the reverse of removal.
|
After replacement or reinstallation procedure of the valve body
assembly, must perform procedures below.
|
•
|
The gasket of the valve body gasket (A) use new one.
|
•
|
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
|
•
|
Perform TCM learning after replacing the valve body to
prevent slow transaxle response, jerky acceleration and jerky
startup. (Refer to "Automatic transaxle control system (Repair
procedures)" in this group)
|
|
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C),
a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake
(UD/B), a 26 brake (26/B), and a 35R clutch ...
See also:
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Fluid Components Location
1. Injection hole(eyebolt)
2. Oil level plug
3. Oil drain plug
...
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...