1. |
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
|
2. |
Check the bearing for damage, abnormal noise and sluggish rotation,
and replace the coolant pump assembly if necessary.
|
3. |
Check for coolant leakage. If coolant leaks from hole, the seal
is defective. Replace the coolant pump assembly and gasket.
|
Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the crankshaft position sensor connector (A) ...