1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the front seat (LH) assembly.
(Refer to the Body group - "Seat")
|
3. |
Disconnect the yaw rate & G sensor connector (A).
|
4. |
Remove the mounting nuts (B).
|
5. |
Installation is the reverse of removal.
|
■ longitudinal G sensor Calibration |
1. |
IG ON, ENG OFF
|
2. |
Stand the vehicle on a flat ground without any inclination.
|
3. |
Set the steering wheel at the center position.
|
4. |
Keep the vehicle under normal tire pressure condition and normal
loading condition.
|
5. |
Connect GDS to Data Link Connector(DLC).
|
6. |
Perform Longitudinal G Sensor Calibration.(figure 1).
|
7. |
Confirm success or failure of calibration.
|
Audio Remote Control Schematic Diagrams
Circuit Diagram (1)
Circuit Diagram (2)
...
Warnings and indicators
All warning lights are checked by turning the ignition switch ON (do not start
the engine). Any light that does not illuminate should be checked by an authorized
Kia dealer.
After starting the en ...
Specification
Item
Bulb Watt (W)
Bulb Type
Front
Head lamp (High)
60/55
H1
Head lamp (Low)
60/55
H7
Position lmap
...