1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the installation nuts (B), and then remove the accelerator
pedal module.
|
Parking brake
Checking the parking brake
Check the stroke of the parking brake by counting the number of “clicks’’ heard
while fully applying it from the released position. Also, the parking brake alone
shou ...
SRS Control Module (SRSCM) Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...