Kia Rio Manuals

Kia Rio: Adjustment - Brake Pedal - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Adjustment

Brake Pedal Height and Free Play
1.
Disconnect the stop lamp switch connector (A).
2.
Adjust the brake pedal height (A) as illustration below.
Pedal height (A): 174.2 mm (6.86 in)
Full stroke (C): 108 mm (4.25 in)


3.
Adjust the stop lamp switch clearance (B).
Stop lamp clearance (B):
1.0 ~ 2.0 mm (0.04 ~ 0.08 in)
4.
Connect the stop lamp switch connector.
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below.
1.
Disconnect the stop lamp switch connector (A).
2.
Pull the locking plate (A) as indicated by the arrow.
3.
Turn stop lamp switch 45° counterclockwise and remove it.
4.
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
5.
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
6.
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance:
1.0 ~ 2.0 mm (0.04~ 0.08 in.)


7.
Connect the stop lamp switch connector.
Installation
1. Installation is the reverse of removal.    • ...

Front Disc Brake
...

See also:

Removal
1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector. 3. Remove the battery ...

Precautions
General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airba ...

Dynamic Damper Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Categories

Copyright www.kirmanual.com 2014-2026