Kia Rio: Cruise Control Switch: Removal - Cruise Control System - Engine Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Cruise Control Switch: Removal

1.
Disconnect the battery (-) terminal.
2.
Remove the air-bag module from the steering wheel. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove the steering wheel. (Refer to Steering System - "Steering Column and Shaft")
4.
Remove the steering wheel cover (A) after loosening 6 screws.


5.
Remove the remote control switch after loosening 2 screws and disconnecting the connector.



Cruise Control Switch: Circuit Diagram
...

Cruise Control Switch: Installation
1. Install in the reverse order of removal. ...

See also:

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

Hazard warning flasher   lighting
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...

Front Hub / Knuckle Reassembly
1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

Copyright © www.kirmanual.com 2014-2020