Kia Rio: Description - Alternator - Charging System - Engine Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Description

The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.
[AMS type (OAD)]


1. Brush
2. OAD (Overrunning Alternator Decoupler)
3. Rotor
4. Stator
5. Rectifier

[AMS type (NON-OAD)]


[ISG type (NON-DAD)]


1. Brush
2. Drive belt pulley
3. Rotor
4. Stator
5. Rectifier

Alternator
...

Specification
[AMS type (NON-OAD)] Item Specification Rated voltage 13.5V, 90A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC ...

See also:

Muffler: Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque Without battery sensor : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...

Removal
1. Disconnect the battery negative terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") ...

Copyright © www.kirmanual.com 2014-2020