Kia Rio Manuals

Kia Rio: Driver Airbag (DAB) Module and Clock Spring Removal - Airbag Module - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Driver Airbag (DAB) Module and Clock Spring Removal

1.
Set the front tires straight-ahead before removing the steering wheel.

     
If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.
2.
Disconnect the battery negative cable.

     
After disconnecting the battery negative cable, wait for at least thirty seconds.
3.
Release the connector locking pin, then disconnect the driver airbag module connector (B).

     
The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
4.
Remove the steering wheel and steering wheel column shroud. (Refer to the Steering System group - "Steering Column and Shaft")
5.
Disconnect the clock spring and horn connector (A), then remove the clock spring.
Driver Airbag (DAB) Module and Clock Spring Components
1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

See also:

Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

Front Stabilizer Bar Replacement
1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Input/ Output Description
Function I/O Connector No Description Active Remark Power B+ A1 Supply power to BCM Power 　 ...

Categories

Copyright www.kirmanual.com 2014-2026