Kia Rio: Fuel Tank Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Rio UB 2012-2024 Service ManualKia Rio: Fuel Tank Removal

1.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
2.
Remove the rear seat [LH] (Refer to “Seat” in BD group).
3.
Remove the fuel pump service cover (A).


4.
Disconnect the fuel pump connector (A).
5.
Disconnect the fuel feed tube quick connector (B).
6.
Disconnect the fuel tank pressure sensor connector (C).
7.
Disconnect the vapor tube (D).


8.
Lift the vehicle and support the fuel tank with a jack.
9.
Remove the center muffler assembly (Refer to “Intake And Exhaust System” in EM group).
10.
Disconnect the fuel filler hose (A) and the vapor hose (B).


11.
Remove the parking brake line installation bolt (A).


12.
Remove the fuel tank from the vehicle after removing the fuel tank band (A).


Release Residual Pressure in Fuel Line
   Whenever the high pressure fuel pump, fuel pipe, delivery pipe, or injector is removed immediately after shutting off th ...

Fuel Tank Installation
1. Installation is reverse of removal. Fuel tank band installation nut: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...

See also:

Rear Hub - Carrier Replacement
[Drum Type] 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Room Lamp Inspection
Room Lamp Remove the room lamp assembly then check for continuity between terminal. If the continuity is not as specified, replace the room lamp assemlby. ...

Power Door Lock Switch Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

Copyright © www.kirmanual.com 2014-2024