Kia Rio: Instrument Cluster Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or romover, remove the cluster fascia panel
(A).
|
| 3. |
Disconnect the start/stop button connector (A) and hazard switch
connector (B).
|
| 4. |
Using a screwdriver or remover, remove the cluster fascia panel
(A).
|
| 5. |
Remove the cluster fascia (A) from the crash pad after removing
2 screws.
|
| 6. |
Disconnect the cluster fascia connecters (A) and then remove the
cluster.
|
Instrument Cluster Inspection
Speedometer
1.
Adjust the pressure of the tires to the specified level.
2.
Drive the vehicle onto a speedometer tester. Use wheel chocks
...
Instrument Cluster Installation
1.
Connect the cluster connector.
2.
Install the cluster assembly.
3.
Install the center fascia panel.
...
See also:
Driver Airbag (DAB) Module and Clock Spring Installation
1.
Set the front tires straight-ahead before assembling the steering
wheel.
...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
2.
Remove the front bumper cover. (Refer to t ...
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by signal from control unit. Pressing the intake selection switch will
shift between recirculation and fresh ai ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026