Kia Rio: License Lamp Installation - Lighting System - Body Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: License Lamp Installation

1.
Install the bulb.
2.
Connect the lens and license lamp.
License Lamp Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens by pushing the clip (A). 3. ...

Hazard Lamp Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or trim remover, remove the hazard lamp switch (A). ...

See also:

Rain Sensor System Function
Basic Principle Emitted Beam from luminosity diode is reflected entirely against the windshield exterior, and then turn into photo diode. If there is water on the windshield exterior, be ...

Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Removal
Engine removal is not required for this procedure.    • Use fender covers to avoid damaging pa ...

Copyright © www.kirmanual.com 2014-2020