Kia Rio: Manual Transaxle Installation - Manual Transaxle Components - Manual Transaxle System - Kia Rio UB 2012-2019 Service ManualKia Rio: Manual Transaxle Installation


     
When replacing a clutch housing or transaxle assembly, the wiring bracket should be installed in accordance with the clutch housing type.
Items
A type
B type
Clutch housing



Wiring bracket




1.
Installation is the reverse of removal.

     
Adding Manual transaxle fluid.
(Refer to "Manual transaxle system" in this group.)
Manual Transaxle Removal
1. Remove the following items; A. Air cleaner assembly (A) and air duct (B) . (Refer to "Intake and Exhaust system" ...

Shift Lever Components
1. Shift lever knob 2. Shift lever assembly 3. Select cable assembly 4. Shift cable assembly 5. Retainer ...

See also:

Engine start/stop button
Illuminated Engine start/stop button Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the d ...

Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Compressor Inspection
1. Check the plated parts of the disc & hub assembly (A) for color changes, peeling or other damage. If there is damage, replace the clutch set. ...

Copyright © www.kirmanual.com 2014-2019