Kia Rio: Mode Control Actuator Description

The mode control actuator is located at the heater unit.

It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

Temperature Control Actuator Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the driver side shower duct (A) after loosening the screw. ...

Mode Control Actuator Inspection

1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

See also:

TPMS Sensor Description
1. Mode (1) Normal Fixed Base State A. Sensor transmissions continue at the Low Line ...

Water pump: Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorma ...

Power Door Lock Switch Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...